W25Q128 FLASH Storage Module SPI Interface 16Mbyte

MOD-145
31 In stock
R 103.50
This unit makes it easy to store your data and the data will not be lost if your microcontroller is powered down or lose power. This unit is the answer for those times your microcontroller just doesn't have enough Flash memory for your application because it will increase the amount...
R 103.50
Terms & conditions

This unit makes it easy to store your data and the data will not be lost if your microcontroller is powered down or lose power. This unit is the answer for those times your microcontroller just doesn't have enough Flash memory for your application because it will increase the amount of data you can store with an additional 16Mbytes.

This module uses your microcontroller’s SPI interface and thus will only require one digital pin to work. Please note that the max volts for this module are 3.6V. More than that will damage the chip, if your microcontroller board has a 3.3V output it will work perfectly with this module.

W25Q128 FLASH Storage Module spec
Capacity: 128M-bit / 16M-byte
The clock frequency: ≤104MHz
Operating voltage: 2.7~3.6V
Size: 14mm * 15mm

Write a review
| Ask a question
Write a review
| Ask a question
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
W25Q128 FLASH Storage Module SPI Interface 16Mbyte
You have successfully subscribed!
This email has been registered