SD Card Module

MOD-130
36 In stock
R 52.79
Read and write data from an SD card using your Arduino. Pin out: Gnd - Gnd on Arduino board3.3V - not used5V - 5V on Arduino board (in code below the 5V can be connected to digital pin 8 to draw power from there)CS -  Digital pin 10MOSI  -  Digital...
R 52.79
Terms & conditions
Read and write data from an SD card using your Arduino.
Pin out:
Gnd - Gnd on Arduino board
3.3V - not used
5V - 5V on Arduino board (in code below the 5V can be connected to digital pin 8 to draw power from there)
CS -  Digital pin 10
MOSI  -  Digital pin 11
SCK  -  Digital pin 13
MISO  -  Digital pin 12
Gnd - not used

Example

sd-card-module-fritzed
#include <SD.h>
//Set by default for the SD Card Library
//MOSI = Pin 11
//MISO = Pin 12
//SCLK = PIN 13
//We always need to set the CS Pin
int CS_pin = 10;
int pow_pin = 8;
float refresh_rate = 0.0;
void setup()
{
  Serial.begin(9600);
  Serial.println("Initializing Card");
  //CS Pin is an output
  pinMode(CS_pin, OUTPUT);
  //Card will Draw Power from Pin 8, so set it high
  pinMode(pow_pin, OUTPUT);
  digitalWrite(pow_pin, HIGH);
  if (!SD.begin(CS_pin))
  {
      Serial.println("Card Failure");
      return;
  }
  Serial.println("Card Ready");
  //Read the Configuration information (COMMANDS.txt)
  File commandFile = SD.open("COMMANDS.txt");
  if (commandFile)
  {
    Serial.println("Reading Command File");
    float decade = pow(10, (commandFile.available() - 1));
    while(commandFile.available())
    {
      float temp = (commandFile.read() - '0');
      refresh_rate = temp*decade+refresh_rate;
      decade = decade/10;
    }
    Serial.print("Refresh Rate = ");
    Serial.print(refresh_rate);
    Serial.println("ms");
  }
  else
  {
    Serial.println("Could not read command file.");
    return;
  }
}
void loop()
{
  String dataString = "Hello";
  //Open a file to write to
  //Only one file can be open at a time
  File logFile = SD.open("LOG.txt", FILE_WRITE);
  if (logFile)
  {
    logFile.println(dataString);
    logFile.close();
    Serial.println(dataString);
  }
  else
  {
Serial.println("LOG.txt");
Serial.println("Couldn’t open log file");
  }
  delay(refresh_rate);
}

 

Write a review
| Ask a question
Write a review
| Ask a question
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
SD Card Module
You have successfully subscribed!
This email has been registered