IRF520 MOSFET Module board

MOD-057
66 In stock
R 19.52
IRF520 MOSFET, gate can be adjusted via PWM output Allows Arduino to drive up to 24V loads, such as LED strips, DC motor, micro pump and solenoid valves Voltage: 3.3V/5V Interface: digital level Output load voltage: 0~24V Output load current: < 5A Suitable for Arduino, SCM, ARM and Raspberry Pi...
R 19.52
Terms & conditions
  • IRF520 MOSFET, gate can be adjusted via PWM output
  • Allows Arduino to drive up to 24V loads, such as LED strips, DC motor, micro pump and solenoid valves
  • Voltage: 3.3V/5V
  • Interface: digital level
  • Output load voltage: 0~24V
  • Output load current: < 5A
  • Suitable for Arduino, SCM, ARM and Raspberry Pi

MOSFET Module sample code
You can simply use the Arduino basic blink sketch to get started and connect the signal pin on the Mosfet board to Arduino digital pin13.

void setup() {
// initialize digital pin 13 as an output.
pinMode(13, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(13, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(13, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}

Write a review
| Ask a question
Write a review
| Ask a question
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
IRF520 MOSFET Module board
You have successfully subscribed!
This email has been registered