CNC 3D Printer Mechanical Endstop

3DA-010
24 In stock
R 27.37
CNC 3D Printer Mechanical Endstop The mechanical endstop uses a lever switch to detect when it is activated. The switch is wired up so that when activated, it pulls the signal to LOW. There is also an LED on the board that will light up when the switch is activated.It...
R 27.37
Terms & conditions

CNC 3D Printer Mechanical Endstop

The mechanical endstop uses a lever switch to detect when it is activated. The switch is wired up so that when activated, it pulls the signal to LOW. There is also an LED on the board that will light up when the switch is activated.It uses a standard 4 pin .100" pitch header and accepts a standard, old-style CD-ROM audio connector cable.

Mechanical Endstop Connection Description:
Red line connecting VCC (ramps of +)
Connect the black wire GND (ramps of -)
Green Line connection SIGNAL (ramps in s)
Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.
Pros: Easy to install, the more common styles
Length of Cable: 70 cm
Size: 32 x 10mm

Write a review
| Ask a question
Write a review
| Ask a question
The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
CNC 3D Printer Mechanical Endstop
You have successfully subscribed!
This email has been registered